Product Introduction:

1. Eliminate the welding marks that cause defects on the surface of the formed product, or reset the position of the welding marks on the surface of the product to improve the quality of the formed product;

2. By adjusting the injection volume of each gate, the quality can be improved to prevent product defects or inadequate filling;

3. Under the control of a time controller, not all gates are opened simultaneously, so injection molding can be carried out under small locking forces;

4. By increasing the injection rate at the gate, the product flow marks can reach a good state.

5. With 2 and 4 time period setting options, the needle valve can be controlled to act once or twice within a working cycle

6. Input can use switch signals, DC24V, and AC 110V/220V inputs

7. The output can choose AC220V, DC24V or switch output, and can be connected to any solenoid valve through pin skipping conversion on the circuit board.

8. It has two working modes to choose from, A and B, with simple parameter settings and stable and reliable operation.

9. Manual valve opening function.